Architecture and engineering of a supramolecular functional material by manipulating the nano-structure of fiber network

Three-dimensional fiber networks were created from an organogel system consisting mainly of elongated fibrils by using a nonionic surfactant as an additive. The presence of the surfactant molecules manipulates the network structure by enhancing the mismatch nucleation on the growing fiber tips. Both the fiber network structure and the rheological properties of the material can be finely tuned by changing the surfactant concentration, which provides a robust approach to the engineering of supramolecular soft functional materials.<br /

Syngenetic sand veins and anti-syngenetic sand wedges, Tuktoyaktuk Coastlands, western Arctic Canada

Sand-sheet deposits of full-glacial age in the Tuktoyaktuk Coastlands, western Arctic Canada, contain syngenetic sand veins 1-21 cm wide and sometimes exceeding 9 m in height. Their tall and narrow, chimney-like morphology differs from that of known syngenetic ice wedges and indicates an unusually close balance between the rate of sand-sheet aggradation and the frequency of thermal-contraction cracking. The sand sheets also contain rejuvenated (syngenetic) sand wedges that have grown upward from an erosion surface. By contrast, sand sheets of postglacial age contain few or sometimes no intraformational sand veins and wedges, suggesting that the climatic conditions were unfavourable for thermal-contraction cracking. Beneath a postglacial sand sheet near Johnson Bay, sand wedges with unusually wide tops (3.9 m) extend down from a prominent erosion surface. The wedges grew vertically downward during deflation of the ground surface, and represent anti-syngenetic wedges. The distribution of sand veins and wedges within the sand sheets indicates that the existence of continuous permafrost during sand-sheet aggradation can be inferred confidently only during full-glacial conditions

Detectionof gas hydrates infaults using azimuthal seismic velocity analysis,Vestnesa Ridge, W-Svalbard Margin

Accepted for publication in Journal of Geophysical Research. Solid Earth. Copyright 2020 American Geophysical Union. Further reproduction or electronic distribution is not permitted.Joint analysis of electrical resistivity and seismic velocity data is primarily used to detect the presence of gas hydrate‐filled faults and fractures. In this study, we present a novel approach to infer the occurrence of structurally‐controlled gas hydrate accumulations using azimuthal seismic velocity analysis. We perform this analysis using ocean‐bottom seismic (OBS) data at two sites on Vestnesa Ridge, W‐Svalbard Margin. Previous geophysical studies inferred the presence of gas hydrates at shallow depths (up to ~190‐195 m below the seafloor) in marine sediments of Vestnesa Ridge. We analyze azimuthal P‐wave seismic velocities in relation with steeply‐dipping near surface faults to study structural controls on gas hydrate distribution. This unique analysis documents directional changes in seismic velocities along and across faults. P‐wave velocities are elevated and reduced by ~0.06‐0.08 km/s in azimuths where the raypath plane lies along the fault plane in the gas hydrate stability zone (GHSZ) and below the base of the GHSZ, respectively. The resulting velocities can be explained with the presence of gas hydrate‐ and free gas‐filled faults above and below the base of the GHSZ, respectively. Moreover, the occurrence of elevated and reduced (>0.05 km/s) seismic velocities in groups of azimuths bounded by faults, suggests compartmentalization of gas hydrates and free gas by fault planes. Results from gas hydrate saturation modelling suggest that these observed changes in seismic velocities with azimuth can be due to gas hydrate saturated faults of thickness greater than 20 cm and considerably smaller than 300 cm

The chronostratigraphy of Late Pleistocene glacial and periglacial aeolian activity in the Tuktoyaktuk Coastlands, NWT, Canada

Aeolian periglacial sand deposits are common in the Tuktoyaktuk Coastlands of Western Arctic Canada. Regionally extensive and thick aeolian sand-sheet deposits have been observed in two major stratigraphic settings: within a sand unit characterized by large aeolian dune deposits; and interbedded with glaciofluvial outwash from the Laurentide Ice Sheet (LIS). Small, localized sand sheets have also been observed along the tops of sandy bluffs, within sequences of drained thermokarst lakes deposits and as an involuted veneer above buried basal ice of the LIS. On the basis of radiocarbon and optically stimulated luminescence (OSL) dates from preserved periglacial aeolian sand sheets and dunes a regional chronostratigraphy is presented which indicates that both extensive dunes and sand sheets accumulated mainly between ca 30 and 13 ka. A switch to dominantly sand-sheet aggradation at ca 14–13 ka, with sand sheets forming widely until ca 8 ka, is attributed to (a) surface armouring by glacial deposits associated with the advance of the LIS; and (b) amelioration of the climate from cold aridity. An absence of OSL dates between ca 8 and 1 ka suggests that sand sheets stabilized during much of the Holocene. Local sand-sheet aggradation during recent centuries has occurred near sandy bluffs and on the floors of drained thermokarst lakes. The OSL dates constrain the maximum extent of the LIS in the Tuktoyaktuk Coastlands to Marine Isotope Stage 2

Simultaneous determination of thermal conductivity, thermal diffusivity and specific heat in sI methane hydrate

This paper is not subject to U.S. copyright. The definitive version was published in Geophysical Journal International 169 (2007), 767–774, doi:10.1111/j.1365-246X.2007.03382.x.Thermal conductivity, thermal diffusivity and specific heat of sI methane hydrate were measured as functions of temperature and pressure using a needle probe technique. The temperature dependence was measured between −20°C and 17°C at 31.5 MPa. The pressure dependence was measured between 31.5 and 102 MPa at 14.4°C. Only weak temperature and pressure dependencies were observed. Methane hydrate thermal conductivity differs from that of water by less than 10 per cent, too little to provide a sensitive measure of hydrate content in water-saturated systems. Thermal diffusivity of methane hydrate is more than twice that of water, however, and its specific heat is about half that of water. Thus, when drilling into or through hydrate-rich sediment, heat from the borehole can raise the formation temperature more than 20 per cent faster than if the formation's pore space contains only water. Thermal properties of methane hydrate should be considered in safety and economic assessments of hydrate-bearing sediment.Gas Hydrate Project of the U.S. Geological Survey’s Coastal and Marine Geology Program, in addition to Department of Energy contract DE-AI21–92MC2921

Sensitivity of the carbon cycle in the Arctic to climate change

The recent warming in the Arctic is affecting a broad spectrum of physical, ecological, and human/cultural systems that may be irreversible on century time scales and have the potential to cause rapid changes in the earth system. The response of the carbon cycle of the Arctic to changes in climate is a major issue of global concern, yet there has not been a comprehensive review of the status of the contemporary carbon cycle of the Arctic and its response to climate change. This review is designed to clarify key uncertainties an vulnerabilities in the response of the carbon cycle of the Arctic to ongoing climatic change. While it is clear that there are substantial stocks of carbon in the Arctic, there are also significant uncertainties associated with the magnitude of organic matter stocks contained in permafrost and the storage of methane hydrates beneath both subterranean and submerged permafrost of the Arctic. In the context of the global carbon cycle, this review demonstrates that the Arctic plays an important role in the global dynamics of both CO2 and CH4. Studies suggest that the Arctic has been a sink for atmospheric CO2 of between 0 and 0.8 Pg C/yr in recent decades, which is between 0% and 25% of the global net land/ocean flux during the 1990s. The Arctic is a substantial source of CH4 to the atmosphere (between 32 and 112 Tg CH4/yr), primarily because of the large area of wetlands throughout the region. Analyses to date indicate that the sensitivity of the carbon cycle of the Arctic during the remainder of the 21st century is highly uncertain. To improve the capability to assess the sensitivity of the carbon cycle of the Arctic to projected climate change, we recommend that (1) integrated regional studies be conducted to link observations of carbon dynamics to the processes that are likely to influence those dynamics, and (2) the understanding gained from these integrated studies be incorporated into both uncoupled and fully coupled carbon–climate modeling efforts

Active mud volcanoes on the continental slope of the Canadian Beaufort Sea

The major geochemical characteristics of Red Sea brine are summarized for 11 brine-filled deeps located along the central graben axis between 19°N and 27°N. The major element composition of the different brine pools is mainly controlled by variable mixing situations of halite-saturated solution (evaporite dissolution) with Red Sea deep water. The brine chemistry is also influenced by hydrothermal water/rock interaction, whereas magmatic and sedimentary rock reactions can be distinguished by boron, lithium, and magnesium/calcium chemistry. Moreover, hydrocarbon chemistry (concentrations and δ 13 C data) of brine indicates variable injection of light hydrocarbons from organic source rocks and strong secondary (bacterial or thermogenic) degradation processes. A simple statistical cluster analysis approach was selected to look for similarities in brine chemistry and to classify the various brine pools, as the measured chemical brine compositions show remarkably strong concentration variations for some elements. The cluster analysis indicates two main classes of brine. Type I brine chemistry (Oceanographer and Kebrit Deeps) is controlled by evaporite dissolution and contributions from sediment alteration. The Type II brine (Suakin, Port Sudan, Erba, Albatross, Discovery, Atlantis II, Nereus, Shaban, and Conrad Deeps) is influenced by variable contributions from volcanic/ magmatic rock alteration. The chemical brine classification can be correlated with the sedimentary and tectonic setting of the related depressions. Type I brine-filled deeps are located slightly off-axis from the central Red Sea graben. A typical " collapse structure formation " which has been defined for the Kebrit Deep by evaluating seismic and geomorphological data probably corresponds to our Type I brine. Type II brine located in depressions in the northern Red Sea (i.e., Conrad and Shaban Deeps) could be correlated to " volcanic intrusion-/extrusion-related " deep formation. The chemical indications for hydrothermal influence on Conrad and Shaban Deep brine can be related to brines from the multi-deeps region in the central Red Sea, where volcanic/magmatic fluid/rock interaction is most obvious. The strongest hydrothermal influence is observed in Atlantis II brine (central multi-deeps region), which is also the hottest Red Sea brine body in 2011 (*68.2 °C)

Discovery of a single male Aedes aegypti (L.) in Merseyside, England

© The Author(s). 2017. This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made. The Creative Commons Public Domain Dedication waiver (http://creativecommons.org/publicdomain/zero/1.0/) applies to the data made available in this article, unless otherwise stated. The file attached is the published (publishers PDF) version of the article